Enclosed Track Overhead Conveyor

Enclosed Track Overhead Conveyor

The enclosed track overhead conveyor uses an upper and lower double-layer C-channel structure, where a power chain inside the upper enclosed track provides continuous traction, and carriers running in the lower track enable accumulation and line switching. This design balances space utilization with independent control of material takt.
Send Inquiry

This enclosed track overhead conveyor consists of enclosed track, power chain, accumulating trolley, carrier, switch, drive station, and take-up station. The upper power chain drives the lower trolley via push dogs, allowing the trolley to stop or store at any set position; the switch enables directional changes horizontally, vertically, or on inclines to form a closed loop.

 

Core Component Configuration

 

Drive Station

SEW reducer motor with rotating floating mechanical overload protection and thermal relay protection; belt-type linear drive unit with adjustable tension wheel for easy chain engagement adjustment.

01

Power Chain

WEEB die-forged detachable chain, theoretical pitch 102.4mm, material 45Mn2, breaking load 186kN, allowable tensile force 15kN, safety factor >12.

02

Take-up Station

Pneumatic tensioning with SMC (Japan) cylinders and air units; end detection switch displays chain slack, jamming, and fracture faults.

03

Track

16Mn alloy steel C-channel, straightened before installation, connection clearance within 0.33mm.

04

Turn Unit

Back-up roller turn and traction wheel turn, with extended lubrication nozzles on bearing shafts.

05

Operation and Maintenance Points

 

Accumulation Logic

When the front shovel of a trolley is lifted by the tail plate of the rear trolley, the lifting claw descends and disengages from the push dog for stopping; upon release, the stop blade opens, and the lifting claw re-engages. This mechanical linkage achieves physical accumulation without relying on electrical signals.

Anti-fall Protection

Anti-backup and anti-runaway devices are installed on incline/decline sections to prevent trolley descent if the chain breaks.

Chain Lubrication

Oil mist auto-lubrication equipment is set at the take-up exit (minimum tension area) for timed pin lubrication; a dedicated grease injection device serves the chain backup trolley.

Expandability

Modular design of track and drive zones allows adding stations or adjusting lines without full tear-down.

 

2.jpg
1.jpg

 

FAQ

Q: How does the enclosed track overhead conveyor prevent trolley impact during accumulation stops?

A: A damper is installed at the transition section from power track to free track, combined with a locator (cylinder-controlled, accuracy within 3mm) to ensure accurate and impact-free stopping.

Q: What detectable fault symptoms appear after power chain elongation?

A: The detection switch at the take-up station end displays chain slack, jamming, and fracture. As pitch increases, the engagement position between push dog and lifting claw shifts, manifesting as running vibration or jamming at switches.

Q: How long a distance can a single drive station cover?

A: A single drive can power a conveyor length of approximately 500 meters; for longer lines, multiple drive stations are required, and synchronization control between drive devices is mandatory.

 

 

 

Hot Tags: enclosed track overhead conveyor, China enclosed track overhead conveyor manufacturers, suppliers, factory, overhead conveyor automation, overhead conveyor disruption, overhead conveyor email marketing, overhead conveyor hazardous materials handling technology, overhead conveyor maintenance manual, overhead conveyor relocation handling