Carriers hang below the track and travel along a predetermined path. Based on carrier and drive variations, common types are classified as free, power, and power-and-free (P&F), differing in whether carriers can stop independently or switch paths without disengaging from the drive chain. Drive forms include chain traction, friction-tube drive, and rope-based ultra-light carrier systems, selected according to load, cleanliness requirements, and the need for station independence.
Configuration Comparison
| Type | Drive Method | Independent Carrier Stop | Typical Application |
| Free | Manual push | Yes | Low-frequency, short transfer |
| Power | Continuous chain | No | Uniform-takt production line |
| Power & Free | Chain + switch/accumulation | Yes | Multi-station lines with buffering |
| Friction-tube | Rotating tube friction | Yes (zone control) | Clean, low-noise environments |
Engineering Constraints
Structural load check
Ceiling/beams must bear track, carrier, material, and dynamic shock loads combined; for old facilities, check suspension margin in original drawings-not static-load estimates.
Curve and switch layout
Sharp curves accelerate wear on chains/drive tubes and joints, directly affecting carrier passability.
Expansion reserve
If stations may be added or removed, choose modular track sections and expandable drive zones to avoid full-line tear-down.
Clean-environment materials
In food/pharma settings, verify carriers avoid fluid-trapping areas; polymer carriers have a documented record of reducing corrosion and harborage points.


FAQ
Q: What are the symptoms of chain elongation in an overhead conveyor system?
A: As chain pitch increases, the carrier's engagement position at the drive end shifts, manifesting as running vibration, increased jamming frequency at switches, and in severe cases, carrier slippage on inclines. Periodically checking chain sag and pitch elongation is a basic preventive maintenance item.
Q: What is the main maintenance difference between friction-tube drive and chain drive?
A: Friction-tube systems require no chain lubrication, reducing the risk of oil drip contamination onto workpieces; wear parts are concentrated on the drive tube and carrier spring-loaded pressure rollers, which can be replaced without disassembling the entire traction chain. Chain drives require periodic lubrication and tension adjustment, and chain joints wear faster in dusty environments.
Q: Can different sections of an overhead conveyor system run at different speeds?
A: Yes. By equipping different zones with drive motors of varying reduction ratios or variable frequency drives, speed zoning can be achieved within the same overhead conveyor system. For example, a coating section can run slowly for pass-through while an empty return section runs faster, improving overall takt efficiency.
Hot Tags: overhead conveyor system, China overhead conveyor system manufacturers, suppliers, factory, overhead conveyor construction handling, overhead conveyor content marketing, overhead conveyor crate handling technology, overhead conveyor disruption, overhead conveyor domestic market, overhead conveyor work in progress handling technology

