In most automotive final assembly plants, vehicle bodies are not suspended from overhead conveyors; instead, they rest on low-profile skids-positioned nearly flush with the floor-while operators work alongside them. This configuration, known as an inverted accumulating skid conveyor system, has become the industry standard for final assembly lines, primarily because it effectively resolves several unavoidable operational challenges.
Consider the workspace: final assembly tasks-such as marriage (joining the body to the chassis/powertrain), fluid filling, tire installation, and electrical inspections-require access to all sides of the vehicle. Overhead conveyor systems often place structural steel and suspension hardware in the way, forcing operators to navigate around these obstructions. In contrast, an inverted system houses the drive chain and transport carriages within a floor trench. The skids move along the top, allowing operators to move freely around them and access the vehicle from any angle-a highly practical advantage for final assembly.
Contamination is another critical factor. While final assembly does not involve immersion tanks, there is always a risk of debris falling from overhead equipment onto a freshly painted vehicle body. An inverted system eliminates this risk entirely by ensuring there are no moving components positioned above the vehicles. (Conversely, overhead conveyors are preferred in paint shops because they keep the product below the track, avoiding the need for the track itself to enter the immersion tanks.)
Accumulation capability addresses a different set of requirements. In a continuous conveyor system, it is impossible to stop one carrier while allowing others to continue moving. An accumulating system decouples the drive chain from the load-carrying carriages; the chain runs continuously, while the carriages engage or disengage via push-dogs and stoppers. If a specific workstation requires more time, a carriage can be disengaged, allowing the drive chain to pass underneath. Carriages can queue ahead of slower workstations, wait for a robot's cycle time, or be diverted to a rework spur-all without requiring the upstream line to stop. In mixed-model production, where workstations must be able to stop independently and require buffers between them, continuous chain conveyors are limited by the speed of the slowest station; accumulating systems break this rigid coupling.
Of course, the inverted system is not without its drawbacks. Installing a floor-level conveyor system requires civil engineering work and drainage provisions; maintenance necessitates accessing areas below the floor surface-unlike ground-level tracks, which can be easily inspected by simply walking up to them. However, given the requirements for vehicle accessibility and workstation independence during final assembly, an inverted (floor-mounted) conveyor system has consistently proven to be the more suitable choice.
It is best to determine the load requirements early in the selection process. In automotive final assembly, skid loads typically range from 500 to 5,000 lbs. The conveyor chain should be selected accordingly: X458-class chains are used for lighter-duty interior trim operations and smaller vehicle bodies, while X678-class chains are employed for full vehicle bodies and heavier skids. Choosing a chain that is too small will lead to premature wear, while selecting one that is too large results in unnecessary expense-and rectifying such issues after the floor trenches have been poured is a highly complex and difficult undertaking.
